Installation manual
CNC 8055
CNC 8055i
8055 CNC CONFIGURATION
1.
SOFT: V02.2X
·37·
Central unit
Monitors with keyboard
Connecting the USB extension cable supplied by Fagor
1. While the CNC is off, connect the extension cable to the CPU and to the keyboard.
2. Once the extension cable has been properly connected, the USB connector of the keyboard may
be used.
Ethernet - CNC configuration in a local network
The Ethernet option permits configuring the CNC as another node within the local area network.
This makes it possible to communicate with other PC’s to transfer files or carry out telediagnosis
tasks.
The Ethernet option does not require having the DNC option available.
The Ethernet card has an RJ-45 connector and two LED's that inform on the status of the connection.
Red LED Blinks while transmitting data.
Green LED On while connected to the network.
Use a standard shielded 10BASE-T cable for this connection. It must not be longer than 100 meters.
Once the connection to Ethernet has been configured, the following types of connections are
possible:
• PC connection through WinDNC (it requires WinDNC version 4.0 or higher).
• Connection from a PC through an FTP client.
• Connection to a remote hard disk.
CPU
X1 X2
CMPCT
FLASH
ETH
COM1
X3
C
D
E
F
0
B
A
9
8
1
7
2
6
3
5
4
IN
OUT
NODE
USB
FAGO R
0
2
4
10
20
30
40
50
60
70
80
90
100
110
120
FEED %
SPINDLE
JOG
100
10
1
1
10
100
1000
10000
Ty pe A
USB
Typ e B
USB
The type B USB connector
is connected on the back
of the keyboard.
Network connection
Transmitting data
To Next Page
Loading...
