·36·
Installation manual
CNC 8055
CNC 8055i
1.
8055 CNC CONFIGURATION
SOFT: V02.2X
Central unit
"USB" port - USB hard disk (Pen Drive) connection.
The USB 1.1 port with type A connector, it admits connecting a "Pendrive" type memory device.
These memory devices are commercially available (off-the-shelf) and they're all valid regardless of
their size, brand name or model.
When using a USB extension cable, it must be a type A - type B cable and no longer than 3 m. It
is also recommended that the cable be double-shielded.
The CNC recognizes the connected device as USB Hard Disk. When it is connected, it will be shown
as <USB hard disk> on the left panel of the <explorer>. To see its contents, press the <update>
(refresh) softkey.
Within the USB device, the CNC will only recognize files with extensions *.f55 (software version),
*fhw (firmware update files), part-programs, parameters, tables, pages (screens) and symbols. The
CNC will not recognize any other type of file. Part-programs cannot be edited or executed from the
USB hard disk.
Separate monitors (without keyboard)
Connecting the USB extension cable supplied by Fagor:
1. Connect the cable and the USB adapter. Check that the seal and the nut of the USB adaptor
are secured as shown in the figure.
2. While the CNC is off, connect the extension cable to the USB connector of the CNC.
3. Once properly connected to the extension cable, the USB devices may be connected through
the adapter.
Do not connect a multi-hub USB adapter to connect several devices at the same time. It will only
recognize the first Pen Drive that is connected. Nor will it recognize other types of devices such as
keyboards, mice, recorders, etc.
USB extension
cable.
USB adapter.
Securing
nut.
Seal.
FAG OR
F1 F2 F3 F4 F5 F6 F7
CPU
X1 X2
CMPCT
FLASH
ETH
COM1
X3
C
D
E
F
0
B
A
9
8
1
7
2
6
3
5
4
IN
OUT
NODE
USB
USB extension
cable.
USB adapter.
To connect USB
devices.
To Next Page
Loading...
