Installation manual
CNC 8055
CNC 8055i
ACCESS TO INTERNAL CNC VARIABLES
13.
SOFT: V02.2X
·571·
Other variables
TIMEG
It shows the timing status of the timer programmed with G4 K in the CNC channel. This variable,
returns the time remaining to end the timing block in hundredths of a second.
TIPPRB
It indicates the PROBE cycle being executed at the CNC.
If PROBE1 is running, the TPPRB variable takes the value of 1, if PROBE2 is running, it takes the
value of 2, etc. if PROBE12 is running, it takes the value of 12.
PANEDI
WINDRAW55 application. Number of the screen created by the user or the manufacturer and is
being consulted.
DATEDI
WINDRAW55 application. Number of the element (item) being consulted.
RIP
Linear theoretical feedrate resulting from the next loop (in mm/min).
The calculation of the resulting feedrate ignores the rotary axes, slave axes (gantry, coupled and
synchronized) as well as DRO axes.
TEMPIn
It returns the temperature in tenths of a degree detected by the PT100. It is possible to select one
of the 4 temperature inputs (1··4) available.
FBDIF(X-C)
Variable that can be read from the CNC, PLC and DNC for monitoring the difference between the
position value of the first and second feedbacks on the oscilloscope with Fagor digital servo system.
If the feedback difference exceeds the value set in axis parameter FBACKDIF (P100) the CNC will
issue the corresponding error message.
This monitoring depends on the value of axis parameter FBACKAL (P11).
CYCLEV
Variable that can be read from CNC, PLC and DNC and indicates (on the conversational model)
the tab number that is being displayed at all times, beginning from 0, when navigating (browsing)
through the cycles. It takes the value of -1 when not navigating (browsing) through the cycles.
Monitoring of the difference between the first and second feedbacks is not possible on CAN axes.
If both feedbacks are connected to the drive, the CNC does not show the difference between them,
but is issues the corresponding error message.
To Next Page
Loading...
