Installation manual
CNC 8055
CNC 8055i
CONFIGURABLE WORK MODE
16.
SOFT: V02.2X
·629·
Example. Machining canned cycle
16.14 Example. Machining canned cycle
It uses the 001 screen. The data shown by this screen have the following identifier (W).
The data that the user may edit in this cycle have the W identifier, the number associated with each
one indicates the order in which they are selected (W1, W2, etc.). W11, W12).
This screen has the P999001 configuration file associated with it. Some of its fields are defined as
follows:
;(PRGSCRIPT 1)
;(HOTKEY W1,88)
;(TEACHIN W1=POSX)
The W1 field has the X hotkey (88) and the X axis coordinate associated with it. In other words:
Pressing the X key selects this field.
While this field is selected, if the Recall key is pressed, it will show the X axis position. If Enter is
then pressed, the cycle assumes that value.
Repeat these instructions for the fields: W2, W3 and W4.
;(HOTKEY W6,83)
;(HOTKEY W7,83)
The W6 and W7 fields have the S (83) hotkey associated with them. In other words:
Pressing the S key selects the W6 field and pressing it again selects the W7 field.
Associate the F key with the W10 field and the T key with the W11 field.
;(END)
End of the debugging of the configuration file and end of program.
Pressing [ESC] displays a cycle-start icon at the top right of the screen and if the [CYCLE START]
is pressed again, it calls the associated subroutine (9001) to execute the cycle.
The 9001 subroutine must be defined by the OEM and must contain all the necessary instructions
to run the canned cycle.
To Next Page
Loading...
