Fagor CNC 8055i FL EN - Page 664

·664·
Installation manual
CNC 8055
CNC 8055i
F.
SOFT: V02.2X
Summary of internal CNC variables.
PLC related variables.
Variables associated with local and global parameters.
Sercos variables.
Software & hardware configuration variables.
Variables associated with telediagnosis.
Variable CNC PLC DNC
PLCMSG R - R Number of the active PLC message with the highest priority.
PLCIn R/W - - 32 PLC inputs starting from (n).
PLCOn R/W - - 32 PLC outputs starting from (n).
PLCMn R/W - - 32 PLC marks starting from (n).
PLCRn R/W - - (n) Register.
PLCTn R/W - - Indicated (n) Timer’s count.
PLCCn R/W - - Indicated (n) Counter’s count.
PLCMMn R/W - - Modifies the (n) mark of the PLC.
Variable CNC PLC DNC
( section 13.13 )
GUP n - R/W - Global parameter (P100-P299) (n), user parameter (P1000-P1255) (n),
OEM parameter (P2000-P2255) (n).
LUP (a,b) - R/W - Indicated local (P0-P25) parameter (b) of the nesting level (a).
CALLP R - - Indicates which local parameters have been defined by means of a PCALL
or MCALL instruction (calling a subroutine).
Variable CNC PLC DNC
( section 13.14 )
SETGE(X-C) W W - Gear ratio and parameter set of the (X-C) axis drive
SETGES W W - Gear ratio and parameter set of the main spindle
SSETGS W W - Gear ratio and parameter set of the second spindle
SVAR(X-C) id R/W - - Sercos variable sercos for the (X-C) axis "id"
SVARS id R/W - - Sercos variable sercos for the main spindle "id"
SSVARS id R/W - - Sercos variable sercos for the second spindle "id"
TSVAR(X-C) id R - - Third attribute of the sercos variable for the (X-C) axis "id"
TSVARS id R - - Third attribute of the sercos variable for the main spindle "id"
TSSVAR id R - - Third attribute of the sercos variable for the second spindle "id"
Variable CNC PLC DNC
( section 13.15 )
HARCON R R R It indicates, with bits, the CNC's hardware configuration.
HARCOA R R R It indicates, with bits, the CNC's hardware configuration.
IDHARH R - R Hardware identifier (8 least significant bits).
IDHARL R R R Hardware identifier (4 most significant bits).
SOFCON R R R Software version of the CNC (bits 15-0) and HD (bits 31-16)
HDMEGA R R R Hard disk size (in megabytes).
KEYIDE R R R Keyboard code, according to the auto-identification system.
MODEL R R R It identifies the CNC model, mill or lather.
Variable CNC PLC DNC
( section 13.16 )
HARSWA R R R Hardware configuration.
HARSWB R R R Hardware configuration.
HARTST RRRHardware test.
MEMTST R R R Memory test.
NODE R R R Node number in the Sercos ring.
VCHECK R R R Software version checksum.
IONODE R R R Position of the "ADDRESS" switch of the I/O CAN bus.
IOSLOC R R R Number of local I/O available.
IOSREM R R R Number of remote I/O available.