·92·
Installation manual
CNC 8055
CNC 8055i
2.
CNC 8055 I CONFIGURATION
SOFT: V02.2X
CNC structure
Separate monitors (without keyboard)
Connecting the USB extension set supplied by Fagor:
1. Connect the cable and the USB adapter. Check that the seal and the nut of the USB adaptor
are secured as shown in the figure.
2. While the CNC is off, connect the extension cable to the USB connector of the CNC.
3. Once the extension set has been properly connected, it will be possible to connect and
disconnect USB devices to the CNC while it is on.
USB extension
cable.
USB adapter.
Securing
nut.
Seal.
OUT IN
X7
X1
X8
X9
X2
X10
X3
X11
X4
X12
X5
X13
X6
+24V
0V
USB extension
cable.
USB adapter.
To connect USB
devices.
FAGOR
F1 F2 F3 F4 F5 F6 F7
To Next Page
Loading...
