Installation manual
CNC 8055
CNC 8055i
CNC 8055 I CONFIGURATION
2.
SOFT: V02.2X
·91·
CNC structure
"USB" port - USB hard disk (Pen Drive) connection.
The USB 1.1 port with type A connector, it admits connecting a "Pendrive" type memory device.
These memory devices are commercially available (off-the-shelf) and they're all valid regardless of
their size, brand name or model.
The CNC recognizes the connected device as USB Hard Disk. When it is connected, it will be shown
as <USB hard disk> on the left panel of the <explorer>. To see its contents, press the <update>
(refresh) softkey.
Within the USB device, the CNC will only recognize files with extensions *.f55 (software version),
*fhw (firmware update files), part-programs, parameters, tables, pages (screens) and symbols. The
CNC will not recognize any other type of file.
Part-programs cannot be edited or executed from the USB hard disk.
USB 1.1 port
USB device
(A)
Use a USB extension cable to prevent undesired short-circuits with the metal housing (A) of the USB
device at the CNC. The extension cable must not be longer than 3 m and it must be plugged in while
the CNC is off.
We recommend to use the extension set supplied by Fagor.
Once this cable has been plugged in, USB devices may be connected or disconnected through it while
the CNC is on.
Do not connect a multi-hub USB adapter to connect several devices at the same time. It will only
recognize the first Pen Drive that is connected. Nor will it recognize other types of devices such as
keyboards, mice, recorders, etc.
To Next Page
Loading...
