Fagor CNC 8060 - Page 105

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·105·
Machine parameters for the axes and spindles.
AXIS CONFIGURATION FOR LATHE TYPE MACHINES.
FACEAXIS
Face axis on a lathe.
Parameter valid for a linear axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.FACEAXIS.xn
See axis machine parameters LONGAXIS.
LONGAXIS
Longitudinal axis on a lathe.
Parameter valid for a linear axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.LONGAXIS.xn
On turning machines, you must indicate which one is the longitudinal axis and which one
is the cross axis.
These parameters only affect the axes that can work in lathe mode. If it is a combined
machine and any or several milling axes can work as lathe, it is necessary to set these
parameters. In some cases, the same axis can work as a face axis (FACEAXIS=Yes) and
as longitudinal axis (LONGAXIS=Yes) and consequently, both parameters must be set to
Ye s .
SYNCHRONIZATION OF AXES AND SPINDLES.
SYNCSET
Set of parameters for synchronization.
Parameter valid for rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 4.
Default value: 1.
Associated variable: (V.)[ch].MPA.SYNCSET.xn
Parameter set assumed by the axis or spindle when it is synchronized. If the parameter is
set to ·0· (zero), the CNC will try to synchronize the spindle without forcing the set change.
• A slave axis or spindle always assumes the set defined in its parameter SYNCSET.
• If the master and slave spindles are in the same channel, master spindle assumes the
set defined in its parameter SYNCSET. If both spindles are in different channels, the
parameter set of the master spindle must be selected before synchronizing.
Typical lathe setting:
X axis. FACEAXIS = Yes LONGAXIS = No
Z axis. FACEAXIS = No LONGAXIS = Yes
Rest of the axes. FACEAXIS = No LONGAXIS = No
Typical Mill setting:
All the axes. FACEAXIS = No LONGAXIS = No