·106·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for the axes and spindles.
DSYNCVELW
Speed synchronization window.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 200000.0000 mm/min / from 0 to 7874.01575 inch/min / from 0 to
36000000.0000 degrees/min / from 0 to 100000 rpm.
Default value: 100 mm/min / 3.937 inch/min / 3600 degrees/min / 10 rpm.
Associated variable: (V.)[ch].MPA.DSYNCVELW.xn
This parameter is defined for the slave element of the synchronization and indicates the
velocity margin admitted for the synchronization to be OK.
When the spindles are synchronized in speed, the slave spindle turns at the same speed
as the master spindle (taking the ratio into account). If the value defined in this parameter
is exceeded, the SYNSPEED signal goes low; the movement is not stopped and no error
message is issued.
When synchronizing axes, the slave axis moves at the same feedrate as the master
(considering the ratio). If the difference between the synchronism speed calculated for the
slave axis and its real speed exceeds the value set in this parameter, it cancels the INSYNC
mark of the PLC.
DSYNCPOSW
Position synchronization window.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 99999.9999 mm/min / from 0 to 3937.00787 inch/min / from 0 to 99999.9999
degrees/min.
Default value: 0.0100 mm/min or degrees/min / 0.00039 inch/min.
Associated variable: (V.)[ch].MPA.DSYNCPOSW.xn
This parameter is defined for the slave element of the synchronization and indicates the
position margin admitted for the synchronization to be OK.
When the spindles are synchronized in position, the slave spindle follows the master keeping
the programmed offset (bearing the ratio in mind) and it activates the SYNCHRONP mark
of the PLC. If the value set in this parameter is exceeded, it cancels the SYNPOSI mark of
the PLC; it does not stop the movement or issue any error message.
When synchronizing axes, the slave axis follows the master keeping the offset (considering
the ratio). If the difference between the synchronism position calculated for the slave axis
and its real position exceeds the value set in this parameter, it cancels the INSYNC mark
of the PLC.
CONFIGURATION OF THE ROTARY AXES.
AXISMODE
Work mode of the rotary axis.
Parameter valid for a rotary axes.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Linearlike / Module.
Default value: Module.
Associated variable: (V.)[ch].MPA.AXISMODE.xn
This parameter indicates how the rotary axis will behave in terms of number of turns or the
display of coordinates.
Behavior when AXISMODE = Module.
The axis behaves like a rotary axis. Movements in G0/G1 and G90/G91 may be programmed.
To Next Page
Loading...
