Fagor CNC 8060 - Page 109

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·109·
Machine parameters for the axes and spindles.
The module compensation must be activated when the axis resolution is not exact. Range
parameters MODNROT and MODERR set the compensation to be applied to obtain the
exact reading. The CNC applies module compensation throughout the entire revolution.
CONFIGURATION OF THE C AXIS.
CAXIS
Possibility to work as a C axis.
Parameter valid for rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.CAXIS.xn
This parameter indicates whether the axis or spindle can work as C axis.
CAXSET
Set of parameters to work as C axis.
Parameter valid for rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 1 to 4.
Default value: 1.
Associated variable: (V.)[ch].MPA.CAXSET.xn
The CNC takes this parameter into consideration only when CAXIS = Yes.
This parameter indicates which set of parameters (NPARSETS) the axis or spindle uses
when it works as C axis.
PERCAX
"C" axis kept active
Parameter valid for rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.PERCAX.xn
The CNC takes this parameter into consideration only when CAXIS = Yes.
This parameter indicates whether the CNC keeps the C axis active or not after executing
M02, M30 or after an emergency or reset. After turning the CNC off, the CNC deactivates
the C axis.
XC work plane. ZC work plane.