Fagor CNC 8060 - Page 121

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·121·
Machine parameters for the axes and spindles.
INCJOGDIST
Distance traveled in incremental jog.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0.0001 to 99999.9999 mm or degrees / from 0 to 3937.00787 inch.
Associated variable: (V.)[ch].MPA.INCJOGDIST[pos].xn
In each parameter, you must set the distance the axis moves every time the jog key is
pressed. The most typical values are those set by default.
INCJOGFEED
Table for incremental jog feedrates.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
This parameter shows the table to define the axis feedrate in each position of the jog selector
switch. The table shows five parameters, one per each position of the operator panel.
INCJOGFEED n
Feedrate in incremental jog.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 200000.0000 mm/min or degrees/min / from 0 to 7873.992 inch/min.
Default value: 1000.0000 mm/min or degrees/min / 39.37008 inch/min.
Associated variable: (V.)[ch].MPA.INCJOGFEED[pos].xn
In each parameter, you must set the axis feedrate.
JOG MODE. HANDWHEELS.
MPGRESOL
Table for handwheel resolution.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
This parameter shows the table to define the resolution of the handwheel in each position
of the jog selector switch. The table shows three parameters, one per each position of the
operator panel.
Parameter. Distance.
INCJOGDIST1 0.0010 mm or degrees / 0.00003937 inch.
INCJOGDIST2 0.0100 mm or degrees / 0.00039370 inch.
INCJOGDIST3 0.1000 mm or degrees / 0.00393700 inch.
INCJOGDIST4 1.0000 mm or degrees / 0.03937007 inch.
INCJOGDIST5 10.000 mm or degrees / 0.39370078 inch.
INCJOGFEED1 Switch position ·1·.
INCJOGFEED2 Switch position ·10·.
INCJOGFEED3 Switch position ·100·.
INCJOGFEED4 Switch position ·1000·.
INCJOGFEED5 Switch position ·10000·.
MPGRESOL1 Switch position ·1·.
MPGRESOL2 Switch position ·10·.
MPGRESOL3 Switch position ·100·.