·168·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for JOG mode.
The CNC numbers the operator panels following the order (sequence) that they occupy in
the CAN bus (Address switch). The first jog panel will be the one with the lowest number and
so on.
JOGKEYDEF n
JOGKEYBD2DEF n
··
JOGKEYBD8DEF n
Axis and moving direction of each jog key.
Associated variable: (V.)MPMAN.JOGKEYDEF[jk] / (V.)MPMAN.JOGKEYkbDEF[jk]
Parameter included in the JOGKEYDEF table.
There is one table for each jog keypad. Each one of these parameter sets the function of
each JOG key. The CNC always offers 15 parameters; if the jog keypad has fewer keys, the
parameters that do not have any keys associated with them will be ignored.
The relationship between these parameters and the jog keys is the following.
The JOG keypad may consist of the following types of keys. Both types of keys may be defined
at the same JOG keypad. To define the behavior of each key, assign to them one of the
following values.
JOG-PANEL LCD-10K
Keys. Meaning.
Keys to define the axis and the jogging direction.
The parameter is set with a value between -1 and +16 (signed). The sign indicates
the positive direction (+) or the negative direction (-) and the number corresponds to
the logic axis, according to parameter AXISNAME.
Keys to define the axis to be jogged.
The parameter is set with a value between 1 and 16 (unsigned) that corresponds to
the logic axis according to parameter AXISNAME.
Keys to define the direction of the movement.
The parameter is set with one of the "+" and "-" values to indicate the moving direction.
Rapid key.
The parameter is set with the "R" value.
1
4
2
5
3
6
789
10 11 12
13 14 15
To Next Page
Loading...
