Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·169·
Machine parameters for JOG mode.
JOGTYPE
Behavior of the jog keys.
Possible values: Pressed axis / Maintained axis.
Default value: Pressed axis.
Associated variable: (V.)MPMAN.JOGTYPE
This parameter is applied when the jog keyboard has different keys for selecting the axis and
the jogging direction. In this case, jogging an axis requires activating both the axis key and
the moving direction.
There are two options, depending on how the jog keyboard has been configured.
• With the "pressed axis" option, the axis will move while both keys are pressed, the axis
key and the direction key.
• With the "maintained axis" option, pressing the axis key will select it. The axis will move
while the direction key is kept pressed. To de-select the axis, press [ESC] or [STOP].
CONFIGURE THE USER KEYS AS JOG KEYS
USERKEYDEF
USERKEYBD2DEF
··
USERKEYBD8DEF
Tables to configure the user keys as jog keys.
These parameters may be used to configure the user keys of each panel as jog keys.
Parameter USERKEYDEF corresponds to the first jog panel, USERKEYBD2DEF to the
second one and so on.
USERKEYDEF n
USERKEYBD2DEF n
··
USERKEYBD8DEF n
Axis and moving direction of each user key.
Associated variable: (V.)MPMAN.USERKEYDEF[uk] / (V.)MPMAN.USERKEYkbDEF[uk]
Parameter included in the USERKEYDEF table.
There is one table for each jog keypad. Each one of these parameter sets the function of
each user key. The CNC always offers 16 parameters; if the jog keypad has fewer keys, the
parameters that do not have any keys associated with them will be ignored.
The relationship between these parameters and the user keys is the following.
The meaning of this parameter is similar to that of machine parameter JOGKEYBDkbDEF.
To define the behavior of each key, assign to them one of the following values:
• They are defined with a value between 1 and 16 (signed) for the keys that define the axis
and the direction. The sign indicates the positive direction (+) or the negative direction
(-) and the number corresponds to the logic axis, according to parameter AXISNAME.
• They are defined with a value between 1 and 16 (unsigned) for the keys that only define
the axis.
JOG-PANEL LCD-10K
To Next Page
Loading...
