Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·209·
Machine parameters for HMI (Interface).
This parameter sets how to operate with the CNC, through the interface.
SFTYPE
(Reserved)
VMENU
Position of the vertical softkey-menu.
Possible values: Left / Right.
Default value: Right.
Depending on hardware, the vertical softkeys F8 through F12 appear on the left or on the
right of the monitor. This parameter may be used to put the vertical softkey menu on the
proper side.
LANGUAGE
Work language.
Default value: English.
Select a language among those available.
ENGLISH SPANISH ITALIAN GERMAN
FRENCH BASQUE PORTUGUESE CHINESE
RUSSIAN CZECK KOREAN
FFORMAT
Display format for the programmed F.
Default value: 5.2.
This parameter sets the numerical format (integers and decimals) for displaying the feedrate
value. If the format is 0.0, the interface assumes the format defined by means of the FGUIM
application.
SFORMAT
Display format for the programmed S.
Default value: 5.1.
This parameter sets the numerical format (integers and decimals) for displaying the spindle
peed value. If the format is 0.0, the interface assumes the format defined by means of the
FGUIM application.
Value. Meaning.
Standard. Default way to operate at the CNC that may be classic or advanced depending
on the CNC model.
Classic. Hotkey-based method to operate to select the work mode (automatic, jog, editor,
etc.).
Advanced. Default operating way for the 8065. Operating method based on the [Main-Menu]
key that shows a main menu to access the various work modes (automatic, jog,
editor, etc.) through softkeys. Hotkeys for direct access can also be used.
This is the standard way of the 8065.
To Next Page
Loading...
