·210·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for HMI (Interface).
KEYBOARD CONFIGURATION.
USERKEY
Customizing the user key.
This table shows the parameters to configure the user key. The table has the following
machine parameters.
FUNCTION
Function of the user key.
Possible values: Windows / Component / Application / CNC OFF / Nothing.
Default value: Nothing.
Parameter included in the USERKEY table.
Depending on the function selected, it is possible to carry out one of the following tasks.
COMPONENT
Access a component of the CNC.
Possible values: Diagnosis / PLC / Machine parameters / DDSSETUP / TUNING
Parameter included in the USERKEY table.
This parameter shows the list of components (work modes) of the CNC that have no preset
key on the operator panel. Besides these components, it will also display the components
created with the tool FGUIM.
APPLICATION
Execute a PC application.
Parameter included in the USERKEY table.
When setting parameter USERKEY=Application, this parameter allows to select the
application The whole application path must be indicated; for example C:\CNC8070 \FAGOR
\ RELEASE \FGUIM.EXE.
CHANGEKEY
Customizing the change key.
This table shows the parameters to configure the change key. The table has the following
machine parameters.
USERKEY
FUNCTION Function of the user key.
COMPONENT Access a component of the CNC.
APPLICATION Execute a PC application.
Value. Meaning.
Windows Minimize the CNC and show the Windows screen.
Component Access a component (work mode) without CNC hotkey.
Appplication Execute an external application, for example the FGUIM.
CNC OFF It turns the CNC application off.
Nothing. Disable the key.
CHANGEKEY
FUNCTION Function of the change key.
SYSMENUMODE Behavior of the system menu.
SYSHMENU Horizontal system menu.
SYSVMENU Vertical system menu.
To Next Page
Loading...
