Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·211·
Machine parameters for HMI (Interface).
FUNCTION
Function of the change key.
Possible values: Next page / Next channel / Menu
Default value: Next page.
Parameter included in the CHANGEKEY table.
Depending on the function selected, it is possible to carry out one of the following tasks.
SYSMENUMODE
Behavior of the system menu.
Possible values: Volatile / Fixed.
Default value: Volatile.
Parameter included in the CHANGEKEY table.
This parameter determines when the system menu is disabled.
SYSHMENU
Horizontal system-menu.
Possible values: Disabled / Pages / Channels / Components.
Default value: Disabled.
Parameter included in the CHANGEKEY table.
See parameter SYSHMENU.
SYSVMENU
Vertical system-menu.
Possible values: Disabled / Pages / Channels / Components.
Default value: Disabled.
Parameter included in the CHANGEKEY table.
This parameter sets the options that will appear on each softkey-menu.
ESCAPEKEY
Customizing the escape key.
This table shows the parameters to configure the escape key. The table has the following
machine parameters.
Value. Meaning.
Next page. The key selects the next page of the active work mode.
Next Channel. The key selects the next channel.
Menu. The key shows the list of channels and pages on the softkey
menus.
Value. Meaning.
Volatile. The softkey menu is disabled when selecting a menu option
or when changing the active component.
Fixed. The softkey menu remains until the change key is pressed
again.
Value. Meaning.
Disabled. The menu will be disabled.
Screens. The menu shows the various pages or screens of the active
work mode.
Channels. The menu shows the available channels.
Components. The menu shows the components or work modes of the
CNC.
ESCAPEKEY
FUNCTION Function associated with the escape key.
NPREVIOUS Maximum number of previous components stored.
To Next Page
Loading...
