Fagor CNC 8060 - Page 333

Installation manual
CNC 8060
CNC 8065
LOGIC CNC INPUTS AND OUTPUTS.
6.
(REF: 1402)
·333·
Tool manager modifiable signals.
SPDLTOCH1
There is a mark for each magazine. The mnemonics for each magazine are the following.
SPDLTOCH1MZ1 (same as SPDLTOCH1)
SPDLTOCH1MZ2 SPDLTOCH1MZ3 SPDLTOCH1MZ4
Use it with an asynchronous magazine with one changer arm. The PLC must set this mark
high (=1) after taking the tool from the spindle to the changer arm 1.
SPDLTOCH2
There is a mark for each magazine. The mnemonics for each magazine are the following.
SPDLTOCH1MZ1 (same as SPDLTOCH1)
SPDLTOCH2MZ2 SPDLTOCH2MZ3 SPDLTOCH2MZ4
Use it with an asynchronous magazine or synchronous with arm. The PLC must set this mark
high (=1) after taking the tool from the spindle to the changer arm 2.
CH1TOMZ
There is a mark for each magazine. The mnemonics for each magazine are the following.
CH1TOMZ1 (can also be programmed as CH1TOMZ)
CH1TOMZ2 CH1TOMZ3 CH1TOMZ4
Use it with an asynchronous magazine or synchronous with arm. The PLC must set this mark
high (=1) after taking the tool from the tool changer arm 1 to the magazine.
CH2TOMZ
There is a mark for each magazine. The mnemonics for each magazine are the following.
CH2TOMZ1 (can also be programmed as CH2TOMZ)
CH2TOMZ2 CH2TOMZ3 CH2TOMZ4
Use it with an asynchronous magazine or synchronous with arm. The PLC must set this mark
high (=1) after taking the tool from the tool changer arm 2 to the magazine.
SPDLTOGR
There is a mark for each channel. The mnemonics for each channel are the following.
SPDLTOGRC1 (can also be programmed as SPDLTOGR)
SPDLTOGRC2 SPDLTOGRC3 SPDLTOGRC4
Use it with a magazine that admits ground tools. The PLC must set this mark high (=1) after
taking the tool from the spindle to ground.
GRTOSPDL
There is a mark for each channel. The mnemonics for each channel are the following.
GRTOSPDLC1 (can also be programmed as GRTOSPDL)
GRTOSPDLC2 GRTOSPDLC3 GRTOSPDLC4
Use it with a magazine that admits ground tools. The PLC must set this mark high (=1) after
taking the tool from the ground to the spindle.
MZTOSPDL
There is a mark for each magazine. The mnemonics for each magazine are the following.
MZTOSPDLMZ1 (can also be programmed as MZTOSPDL)
MZTOSPDLMZ2 MZTOSPDLMZ3 MZTOSPDLMZ4