·334·
Installation manual
CNC 8060
CNC 8065
6.
LOGIC CNC INPUTS AND OUTPUTS.
(REF: 1402)
Tool manager modifiable signals.
Use it with a synchronous magazine (without arm). The PLC must set this mark high (=1)
after taking the tool from the magazine to the spindle.
SPDLTOMZ
There is a mark for each magazine. The mnemonics for each magazine are the following.
SPDLTOMZ1 (can also be programmed as SPDLTOMZ)
SPDLTOMZ2 SPDLTOMZ3 SPDLTOMZ4
Use it with a synchronous magazine (without arm). The PLC must set this mark high (=1)
after taking the tool from the spindle to the magazine.
MZROT
There is a mark for each magazine. The mnemonics for each magazine are the following.
MZROTMZ1 (can also be programmed as MZROT)
MZROTMZ2 MZROTMZ3 MZROTMZ4
Use it with a turret type magazine. The PLC must set this mark high (=1) when the turret has
rotated.
TCHANGEOK
There is a mark for each magazine. The mnemonics for each magazine are the following.
TCHANGEOKMZ1 (same as TCHANGEOK)
TCHANGEOKMZ2 TCHANGEOKMZ3 TCHANGEOKMZ4
The PLC must set this mark high (=1) when the tool change has ended (M06).
MZPOS
There is a register for each magazine. The mnemonics for each magazine are the following.
MZPOSMZ1 (can also be programmed as MZPOS)
MZPOSMZ2 MZPOSMZ3 MZPOSMZ4
The PLC must indicate the current magazine position in this register.
To Next Page
Loading...
