·560·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the machine parameters of the channels.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.ALIGNC
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. "C" axis alignment for diametrical machining.
This parameter indicates whether the C axis must be aligned for diameter machining
(ALIGNC = Yes) or the tool can machine the whole surface diametrically in a single fixturing
operation (ALIGNC = NO).
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
TIME SETTING (CHANNEL).
(V.)[ch].MPG.PREPFREQ
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Maximum number of blocks to prepare per cycle.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.ANTIME
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Anticipation time.
Syntax.
·ch· Channel number.
CONFIGURATION OF THE HSC MODE (CHANNEL).
(V.)[ch].MPG.FEEDAVRG
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Calculating feedrate average.
[2].MPG.CAXNAME Channel ·2·.
V.[2].MPG.ALIGNC Channel ·2·.
Value. Meaning.
0No.
1Yes.
V.[2].MPG.PREPFREQ Channel ·2·.
V.[2].MPG.ANTIME Channel ·2·.
To Next Page
Loading...
