Fagor CNC 8060 - Page 561

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·561·
Variables related to the machine parameters of the channels.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPG.SMOOTHFREQ
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Smoothing frequency in the interpolation.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.CORNER
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Maximum angle of the corner to machine it in square corner mode.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.HSCFILTFREQ
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Filter frequency (CONTERROR mode).
Syntax.
·ch· Channel number.
(V.)[ch].MPG.FASTFACTOR
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Default feedrate percentage (FAST mode).
Syntax.
·ch· Channel number.
(V.)[ch].MPG.FTIMELIM
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Time difference permitted in feedrate interpolation (FAST mode).
V.[2].MPG.FEEDAVRG Channel ·2·.
Value. Meaning.
0No.
1Yes.
V.[2].MPG.SMOOTHFREQ Channel ·2·.
V.[2].MPG.CORNER Channel ·2·.
V.[2].MPG.HSCFILTFREQ Channel ·2·.
V.[2].MPG.FASTFACTOR Channel ·2·.