Fagor CNC 8060 - Page 565

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·565·
Variables related to the machine parameters of the channels.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPG.LINKCANCEL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Cancel axis coupling by default.
The channel assumes the default value after executing an M02 or M30, after an emergency
or a Reset. To couple axes from the part-program, use the #LINK instruction.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPG.MIRRORCANCEL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Cancel mirror image (G11/G12/G13/G14) after M30 and reset.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPG.SLOPETYPE
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Default acceleration type.
It indicates the type of acceleration applied by default in automatic movements. When
working in manual (JOG) mode, the CNC always applies linear acceleration.
V.[2].MPG.CSCANCEL Channel ·2·.
Value. Meaning.
0No.
1Yes.
V.[2].MPG.LINKCANCEL Channel ·2·.
Value. Meaning.
0No.
1Yes.
V.[2].MPG.MIRRORCANCEL Channel ·2·.
Value. Meaning.
0No.
1Yes.