·564·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the machine parameters of the channels.
(V.)[ch].MPG.VIRTAXCANCEL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Cancel the virtual tool axis after an M30 and Reset.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
DEFAULT CONDITIONS (CHANNEL).
(V.)[ch].MPG.KINID
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Default kinematics number.
The channel assumes the default value on power-up, after executing an M02 or M30 or after
a Reset. To select another kinematics from the part-program, use the #KIN ID instruction.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPG.CSCANCEL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Cancel the inclined plane on start-up.
This parameter indicates whether on start-up the CNC cancels the inclined plane
(#CS/#ACS) that was active when the CNC was turned off.
U=40 U1=41 U2=42 U3=43 U4=44 ... U9=49
V=50 V1=51 V2=52 V3=53 V4=54 ... V9=59
W=60 W1=61 W2=62 W3=63 W4=64 ... W9=69
A=70 A1=71 A2=72 A3=73 A4=74 ... A9=79
B=80 B1=81 B2=82 B3=83 B4=84 ... B9=89
C=90 C1=91 C2=92 C3=93 C4=94 ... C9=99
V.[2].MPG.VIRTAXCANCEL Channel ·2·.
Value. Meaning.
0No.
1Yes.
V.[2].MPG.KINID Channel ·2·.
Value. Meaning.
0 The CNC restores the last kinematics active.
1··6 Default kinematics number.
255 There is no default kinematics.
To Next Page
Loading...
