Fagor CNC 8060 - Page 591

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·591·
Variables related to axis and spindle machine parameters.
Remarks.
The reading from the PLC will be given in tenths (x10); i.e. if the parameter value is ·10·, the
PLC reading will return a value of ·100·.
(V.)[ch].MPA.UPSPDLIM.sn
(V.)[ch].SP.UPSPDLIM.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Upper "rpm OK" percentage.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
Remarks.
The reading from the PLC will be given in tenths (x10); i.e. if the parameter value is ·10·, the
PLC reading will return a value of ·100·.
(V.)[ch].MPA.SPDLTIME.sn
(V.)[ch].SP.SPDLTIME.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Estimated time for an S function.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
(V.)[ch].MPA.SPDLSTOP.sn
(V.)[ch].SP.SPDLSTOP.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Functions M2 and M30, an error or a reset stop the spindle.
Syntax.
·ch· Channel number.
V.MPA.UPSPDLIM.S Spindle S.
V.SP.UPSPDLIM.S Spindle S.
V.SP.UPSPDLIM Master spindle.
V.MPA.UPSPDLIM.4 Spindle with logic number ·4·.
V.SP.UPSPDLIM.2 Spindle with index ·2· in the system.
V.[2].SP.UPSPDLIM.1 Spindle with index ·1· in the channel ·2·.
V.MPA.SPDLTIME.S Spindle S.
V.SP.SPDLTIME.S Spindle S.
V.SP.SPDLTIME Master spindle.
V.MPA.SPDLTIME.4 Spindle with logic number ·4·.
V.SP.SPDLTIME.2 Spindle with index ·2· in the system.
V.[2].SP.SPDLTIME.1 Spindle with index ·1· in the channel ·2·.