·592·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to axis and spindle machine parameters.
·sn· Name, logic number or index of the spindle.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPA.SREVM05.sn
(V.)[ch].SP.SREVM05.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. With G84, the spindle must be stopped to change the turning direction.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPA.M19SPDLEREV.sn
(V.)[ch].SP.M19SPDLEREV.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drives.
The variable returns the value of block preparation.
Channel [ch]. The SPDLEREV mark (reverse turning direction) affects the spindle in M19.
Syntax.
·ch· Channel number.
V.MPA.SPDLSTOP.S Spindle S.
V.SP.SPDLSTOP.S Spindle S.
V.SP.SPDLSTOP Master spindle.
V.MPA.SPDLSTOP.4 Spindle with logic number ·4·.
V.SP.SPDLSTOP.2 Spindle with index ·2· in the system.
V.[2].SP.SPDLSTOP.1 Spindle with index ·1· in the channel ·2·.
Value. Meaning.
0No.
1Yes.
V.MPA.SREVM05.S Spindle S.
V.SP.SREVM05.S Spindle S.
V.SP.SREVM05 Master spindle.
V.MPA.SREVM05.4 Spindle with logic number ·4·.
V.SP.SREVM05.2 Spindle with index ·2· in the system.
V.[2].SP.SREVM05.1 Spindle with index ·1· in the channel ·2·.
Value. Meaning.
0No.
1Yes.
To Next Page
Loading...
