Fagor CNC 8060 - Page 593

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·593·
Variables related to axis and spindle machine parameters.
·sn· Name, logic number or index of the spindle.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPA.STEPOVR.sn
(V.)[ch].SP.STEPOVR.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Spindle override step.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
Remarks.
The reading from the PLC will be given in tenths (x10); i.e. if the parameter value is ·10·, the
PLC reading will return a value of ·100·.
(V.)[ch].MPA.MINOVR.sn
(V.)[ch].SP.MINOVR.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Minimum override (%) permitted for the spindle.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
V.MPA.M19SPDLEREV.S Spindle S.
V.SP.M19SPDLEREV.S Spindle S.
V.SP.M19SPDLEREV Master spindle.
V.MPA.M19SPDLEREV.4 Spindle with logic number ·4·.
V.SP.M19SPDLEREV.2 Spindle with index ·2· in the system.
V.[2].SP.M19SPDLEREV.1 Spindle with index ·1· in the channel ·2·.
Value. Meaning.
0No.
1Yes.
V.MPA.STEPOVR.S Spindle S.
V.SP.STEPOVR.S Spindle S.
V.SP.STEPOVR Master spindle.
V.MPA.STEPOVR.4 Spindle with logic number ·4·.
V.SP.STEPOVR.2 Spindle with index ·2· in the system.
V.[2].SP.STEPOVR.1 Spindle with index ·1· in the channel ·2·.
V.MPA.MINOVR.S Spindle S.
V.SP.MINOVR.S Spindle S.
V.SP.MINOVR Master spindle.