Fagor CNC 8060 - Page 604

·604·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to axis and spindle machine parameters.
CONFIGURE THE MAXIMUM SAFETY LIMIT FOR THE
FEEDRATE AND FOR THE SPEED.
(V.)[ch].MPA.FLIMIT.xn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Maximum safety limit for axis feedrate.
Syntax.
·ch· Channel number.
·xn· Name, logic number or index of the axis.
(V.)[ch].MPA.SLIMIT.sn
(V.)[ch].SP.SLIMIT.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Maximum safety limit for spindle speed.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
JOG MODE. CONTINUOUS JOG.
(V.)[ch].MPA.JOGFEED.xn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
Variable valid for rotary and linear axes.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Feedrate in continuous jog.
Syntax.
·ch· Channel number.
V.[2].MPA.POSFEED.1 Axis with index ·1· in the channel ·2·.
V.SP.POSFEED.2 Spindle with index ·2· in the system.
V.[2].SP.POSFEED.1 Spindle with index ·1· in the channel ·2·.
V.MPA.FLIMIT.Z Z axis.
V.MPA.FLIMIT.4 Axis with logic number ·4·.
V.[2].MPA.FLIMIT.1 Axis with index ·1· in the channel ·2·.
V.MPA .SLIMIT.S Spindle S.
V.SP.SLIMIT.S Spindle S.
V.SP.SLIMIT Master spindle.
V.MPA .SLIMIT.4 Spindle with logic number ·4·.
V.SP.SLIMIT.2 Spindle with index ·2· in the system.
V.[2].SP.SLIMIT.1 Spindle with index ·1· in the channel ·2·.