Fagor CNC 8060 - Page 655

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·655·
Variables related to the sets of machine parameters.
(V.)[ch].MPA.MODLOWLIM[set].xn
(V.)[ch].MPA.MODLOWLIM[set].sn
(V.)[ch].SP.MODLOWLIM[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
Variable valid for rotary axes and spindles.
Variable valid for analog drives and velocity-Sercos drives.
The variable returns the execution value; reading it interrupts block preparation.
Lower limit of the module.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
(V.)[ch].MPA.MODNROT[set].xn
(V.)[ch].MPA.MODNROT[set].sn
(V.)[ch].SP.MODNROT[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
Variable valid for rotary axes and spindles.
Variable valid for analog drives and velocity-Sercos drives.
The variable returns the execution value; reading it interrupts block preparation.
Module error. Number of turns.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
V.MPA.MODUPLIM[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.MODUPLIM[3].1 Axis with index ·1· in the channel ·2·.
V.SP.MODUPLIM[3].2 Spindle with index ·2· in the system.
V.[2].SP.MODUPLIM[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA.MODLOWLIM[3].Z Z axis.
V.MPA.MODLOWLIM[3].S Spindle S.
V.SP.MODLOWLIM[3].S Spindle S.
V.SP.MODLOWLIM[3] Master spindle.
V.MPA.MODLOWLIM[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.MODLOWLIM[3].1 Axis with index ·1· in the channel ·2·.
V.SP.MODLOWLIM[3].2 Spindle with index ·2· in the system.
V.[2].SP.MODLOWLIM[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA.MODNROT[3].Z Z axis.
V.MPA.MODNROT[3].S Spindle S.
V.SP.MODNROT[3].S Spindle S.
V.SP.MODNROT[3] Master spindle.
V.MPA.MODNROT[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.MODNROT[3].1 Axis with index ·1· in the channel ·2·.
V.SP.MODNROT[3].2 Spindle with index ·2· in the system.
V.[2].SP.MODNROT[3].1 Spindle with index ·1· in the channel ·2·.