Fagor CNC 8060 - Page 660

·660·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the sets of machine parameters.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPA.COUNTERTYPE[set].xn
(V.)[ch].MPA.COUNTERTYPE[set].sn
(V.)[ch].SP.COUNTERTYPE[set].sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drives and velocity-Sercos drives.
The variable returns the value of block preparation.
Type of feedback input for the axis.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
Values of the variable.
This variable returns one of the following values.
V.SP.ANAOUTID[3] Master spindle.
V.MPA.ANAOUTID[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.ANAOUTID[3].1 Axis with index ·1· in the channel ·2·.
V.SP.ANAOUTID[3].2 Spindle with index ·2· in the system.
V.[2].SP.ANAOUTID[3].1 Spindle with index ·1· in the channel ·2·.
Value. Meaning.
1 - 16 The analog command is taken from the remote modules. The variable returns the
number of the analog output.
101 -132
201 - 232
The analog command is taken from a Sercos drive. The first digit indicates the analog
output to be used (1 or 2) and the other two digits indicate the logic address of the
drive (1 through 32).
1 - 32 The analog command is taken from an RCS-S module.. The variable returns the
number of the analog output.
V.MPA.COUNTERTYPE[3].Z Z axis.
V.MPA.COUNTERTYPE[3].S Spindle S.
V.SP.COUNTERTYPE[3].S Spindle S.
V.SP.COUNTERTYPE[3] Master spindle.
V.MPA.COUNTERTYPE[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.COUNTERTYPE[3].1 Axis with index ·1· in the channel ·2·.
V.SP.COUNTERTYPE[3].2 Spindle with index ·2· in the system.
V.[2].SP.COUNTERTYPE[3].1 Spindle with index ·1· in the channel ·2·.
Value. Meaning.
0 Remote feedback input.
1 Local feedback input.
2 Feedback input of a Sercos drive.
3 Feedback input of an RCS-S module.