Fagor CNC 8060 - Page 661

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·661·
Variables related to the sets of machine parameters.
(V.)[ch].MPA.COUNTERID[set].xn
(V.)[ch].MPA.COUNTERID[set].sn
(V.)[ch].SP.COUNTERID[set].sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drives and velocity-Sercos drives.
The variable returns the value of block preparation.
Number of the feedback input associated with the axis.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
Values of the variable.
This variable returns one of the following values.
SET THE DRIVE ASSOCIATED WITH THE AXES OF A MULTI-
AXIS GROUP.
(V.)[ch].MPA.DRIVESET[set].xn
(V.)[ch].MPA.DRIVESET[set].sn
(V.)[ch].SP.DRIVESET[set].sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for position-Sercos drives and velocity-Sercos drives.
The variable returns the value of block preparation.
At the axes that belong to a multi-axis group, parameter DRIVESET indicates the set to be
activated at the drive after a set or gear change at the CNC (G112 and M41 to M44).
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
V.MPA.COUNTERID[3].Z Z axis.
V.MPA.COUNTERID[3].S Spindle S.
V.SP.COUNTERID[3].S Spindle S.
V.SP.COUNTERID[3] Master spindle.
V.MPA.COUNTERID[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.COUNTERID[3].1 Axis with index ·1· in the channel ·2·.
V.SP.COUNTERID[3].2 Spindle with index ·2· in the system.
V.[2].SP.COUNTERID[3].1 Spindle with index ·1· in the channel ·2·.
Value. Meaning.
1 - 40 Number of the remote feedback input.
1 - 32 Address of the Sercos drive (always the second feedback input).
1 - 2 Number of the local feedback input.
1 - 32 Number of the RCS-S module input.
V.MPA.DRIVESET[3].Z Z axis.
V.MPA.DRIVESET[3].S Spindle S.
V.SP.DRIVESET[3].S Spindle S.