Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·691·
PLC consulting logic signals; general.
(V.)PLC.FHOUT
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The CNC channel activates this mark when the execution of the part-program is interrupted.
(V.)PLC._ALARM
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel turns this mark off when there is an alarm or an emergency in the channel.
(V.)PLC.MANUAL
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when the jog mode is selected.
(V.)PLC.AUTOMAT
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when the automatic mode is selected.
V.PLC.FHOUT Channel ·1·.
V.PLC.FHOUTC1 Channel ·1·.
V.PLC.FHOUTC2 Channel ·2·.
V.PLC.FHOUTC3 Channel ·3·.
V.PLC.FHOUTC4 Channel ·4·.
V.PLC._ALARM Channel ·1·.
V.PLC._ALARMC1 Channel ·1·.
V.PLC._ALARMC2 Channel ·2·.
V.PLC._ALARMC3 Channel ·3·.
V.PLC._ALARMC4 Channel ·4·.
V.PLC.MANUAL Channel ·1·.
V.PLC.MANUALC1 Channel ·1·.
V.PLC.MANUALC2 Channel ·2·.
V.PLC.MANUALC3 Channel ·3·.
V.PLC.MANUALC4 Channel ·4·.
V.PLC.AUTOMAT Channel ·1·.
V.PLC.AUTOMATC1 Channel ·1·.
V.PLC.AUTOMATC2 Channel ·2·.
V.PLC.AUTOMATC3 Channel ·3·.
V.PLC.AUTOMATC4 Channel ·4·.
To Next Page
Loading...
