Fagor CNC 8060 - Page 692

·692·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC consulting logic signals; general.
(V.)PLC.MDI
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when the MDI/MDA mode is selected.
(V.)PLC.SBOUT
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when the single-block mode is selected.
(V.)PLC.INCYCLE
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when it is executing a block or moving an axis.
(V.)PLC.RAPID
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when it is executing a rapid positioning (G00).
V.PLC.MDI Channel ·1·.
V.PLC.MDIC1 Channel ·1·.
V.PLC.MDIC2 Channel ·2·.
V.PLC.MDIC3 Channel ·3·.
V.PLC.MDIC4 Channel ·4·.
V.PLC.SBOUT Channel ·1·.
V.PLC.SBOUTC1 Channel ·1·.
V.PLC.SBOUTC2 Channel ·2·.
V.PLC.SBOUTC3 Channel ·3·.
V.PLC.SBOUTC4 Channel ·4·.
V.PLC.INCYCLE Channel ·1·.
V.PLC.INCYCLEC1 Channel ·1·.
V.PLC.INCYCLEC2 Channel ·2·.
V.PLC.INCYCLEC3 Channel ·3·.
V.PLC.INCYCLEC4 Channel ·4·.
V.PLC.RAPID Channel ·1·.
V.PLC.RAPIDC1 Channel ·1·.
V.PLC.RAPIDC2 Channel ·2·.
V.PLC.RAPIDC3 Channel ·3·.
V.PLC.RAPIDC4 Channel ·4·.