Fagor CNC 8060 - Page 693

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·693·
PLC consulting logic signals; general.
(V.)PLC.ZERO
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates this mark when searching home (G74).
(V.)PLC.PROBE
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when it is executing a probing movement (G100).
(V.)PLC.THREAD
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when it is executing an electronic threading (G33).
(V.)PLC.TAPPING
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when it is executing a tapping canned cycle.
V.PLC.ZERO Channel ·1·.
V.PLC.ZEROC1 Channel ·1·.
V.PLC.ZEROC2 Channel ·2·.
V.PLC.ZEROC3 Channel ·3·.
V.PLC.ZEROC4 Channel ·4·.
V.PLC.PROBE Channel ·1·.
V.PLC.PROBEC1 Channel ·1·.
V.PLC.PROBEC2 Channel ·2·.
V.PLC.PROBEC3 Channel ·3·.
V.PLC.PROBEC4 Channel ·4·.
V.PLC.THREAD Channel ·1·.
V.PLC.THREADC1 Channel ·1·.
V.PLC.THREADC2 Channel ·2·.
V.PLC.THREADC3 Channel ·3·.
V.PLC.THREADC4 Channel ·4·.
V.PLC.TAPPING Channel ·1·.
V.PLC.TAPPINGC1 Channel ·1·.
V.PLC.TAPPINGC2 Channel ·2·.
V.PLC.TAPPINGC3 Channel ·3·.
V.PLC.TAPPINGC4 Channel ·4·.