Fagor CNC 8060 - Page 694

·694·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC consulting logic signals; general.
(V.)PLC.RIGID
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when it is executing a rigid tapping cycle (G63).
(V.)PLC.CSS
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates this mark when constant surface speed (G96 ) is active.
(V.)PLC.INTEREND
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when the theoretical movement of the axes is completed.
(V.)PLC.INPOSI
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when the axes are in position. This mark also remains active
during the movement of independent axes.
(V.)PLC.SPN1
(V.)PLC.SPN2
(V.)PLC.SPN3
(V.)PLC.SPN4
(V.)PLC.SPN5
V.PLC.RIGID Channel ·1·.
V.PLC.RIGIDC1 Channel ·1·.
V.PLC.RIGIDC2 Channel ·2·.
V.PLC.RIGIDC3 Channel ·3·.
V.PLC.RIGIDC4 Channel ·4·.
V.PLC.CSS Channel ·1·.
V.PLC.CSSC1 Channel ·1·.
V.PLC.CSSC2 Channel ·2·.
V.PLC.CSSC3 Channel ·3·.
V.PLC.CSSC4 Channel ·4·.
V.PLC.INT EREND Channel ·1·.
V.PLC.INTERENDC1 Channel ·1·.
V.PLC.INTERENDC2 Channel ·2·.
V.PLC.INTERENDC3 Channel ·3·.
V.PLC.INTERENDC4 Channel ·4·.
V.PLC.INPOSI Channel ·1·.
V.PLC.INPOSIC1 Channel ·1·.
V.PLC.INPOSIC2 Channel ·2·.
V.PLC.INPOSIC3 Channel ·3·.
V.PLC.INPOSIC4 Channel ·4·.