·700·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC consulting logic signals; general.
(V.)PLC.OVERTEMP
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
This mark indicates the temperature status of the CNC. This mark is deactivated while the
CNC temperature is correct. When the CNC temperature exceeds the maximum allowed
(60 ºC, 140 ºF), the CNC activates this mark and issues a warning to indicate this situation.
The CNC will deactivate this mark when the temperature of the unit goes below the maximum
allowed. The CNC checks its temperature every minute.
(V.)PLC.MLINKRDY
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The CNC activates the mark when the Mechatrolink bus has been initialized properly.
V.PLC.OVERTEMP
V.PLC.MLINKRDY
To Next Page
Loading...
