Fagor CNC 8060 - Page 699

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·699·
PLC consulting logic signals; general.
(V.)PLC.RETRAEND
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates this mark to cancel the retrace function.
(V.)PLC.TANGACTIV
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when a tangential control is active.
(V.)PLC.PSWSET
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The CNC activates this mark when there is an OEM password.
(V.)PLC.DINDISTC1
(V.)PLC.DINDISTC2
(V.)PLC.DINDISTC3
(V.)PLC.DINDISTC4
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
These marks are related to the dynamic machining distribution between channels
(#DINDIST instruction), for the option to distribute passes between channels. During the
roughing operation of the cycle, the CNC channel activates these marks to indicate which
channel has the cycle been programmed in and which are the channels involved in the
distribution of the passes. During the finishing operation, the CNC channel cancels all these
marks.
(V.)PLC.SERPLCAC
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
This mark is related to the change of the work set or of the parameter set of a Sercos drive
(variable (V.)[ch].A.SETGE.xn). The CNC activates the mark to indicate that the requested
change is being carried out.
V.PLC.RETRAENDC1 Channel ·1·.
V.PLC.RETRAENDC2 Channel ·2·.
V.PLC.RETRAENDC3 Channel ·3·.
V.PLC.RETRAENDC4 Channel ·4·.
V.PLC.TANGACTIVC1 Channel ·1·.
V.PLC.TANGACTIVC2 Channel ·2·.
V.PLC.TANGACTIVC3 Channel ·3·.
V.PLC.TANGACTIVC4 Channel ·4·.
V.PLC.PSWSET
(V.)PLC.DINDISTC1
(V.)PLC.DINDISTC2
(V.)PLC.DINDISTC3
(V.)PLC.DINDISTC4
V.PLC.SERPLCAC