Fagor CNC 8060 - Page 698

·698·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC consulting logic signals; general.
(V.)PLC.ADVINPOS
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates a certain amount of time before the axes reach position. The amount
of time is set by parameter ANTIME.
(V.)PLC.CAXIS
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The CNC channel sets this mark when there is a spindle working as C axis. This mark is kept
active while any of the functions #CAX, #FACE or #CYL are kept active.
(V.)PLC.FREE
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when it can accept a block sent with CNCEX.
(V.)PLC.WAITOUT
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when it is waiting for a synchronism signal.
(V.)PLC.MMCWDG
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The CNC activates this mark when the operating system is locked up.
V.PLC.ADVINPOS Channel ·1·.
V.PLC.ADVINPOSC1 Channel ·1·.
V.PLC.ADVINPOSC2 Channel ·2·.
V.PLC.ADVINPOSC3 Channel ·3·.
V.PLC.ADVINPOSC4 Channel ·4·.
V.PLC.CAXIS Channel ·1·.
V.PLC.CAXISC1 Channel ·1·.
V.PLC.CAXISC2 Channel ·2·.
V.PLC.CAXISC3 Channel ·3·.
V.PLC.CAXISC4 Channel ·4·.
V.PLC.FREEC1 Channel ·1·.
V.PLC.FREEC2 Channel ·2·.
V.PLC.FREEC3 Channel ·3·.
V.PLC.FREEC4 Channel ·4·.
V.PLC.WAITOUTC1 Channel ·1·.
V.PLC.WAITOUTC2 Channel ·2·.
V.PLC.WAITOUTC3 Channel ·3·.
V.PLC.WAITOUTC4 Channel ·4·.
V.PLC.MMCWDG