Fagor CNC 8060 - Page 697

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·697·
PLC consulting logic signals; general.
(V.)PLC.DM09
(V.)PLC.DM30
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The CNC indicates in these marks the status of the M functions. This mark is active if the
M function is active.
Each one of functions M00, M01, M02, M06, M08, M09, M30 has a mark for each channel.
Here is an example of the mnemonics for DM00; it is the same for the rest of the marks (DM01,
DM02, DM06, DM08, DM09, DM30).
(V.)PLC.DM03
(V.)PLC.DM04
(V.)PLC.DM05
(V.)PLC.DM19
(V.)PLC.DM41
(V.)PLC.DM42
(V.)PLC.DM43
(V.)PLC.DM44
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The CNC indicates in these marks the status of the spindle M functions. This mark is active
if the M function is active.
Each one of functions M03, M04, M05, M19, M41, M42, M43, M44 has a mark for each
spindle. Here is an example of the mnemonics for DM03; it is the same for the rest of the
marks (DM04, DM05, DM19, DM41, DM42, DM43, DM44).
(V.)PLC.BLKSEARCH
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when the block-search mode is active.
V.PLC.DM00 Channel ·1·.
V.PLC.DM00C1 Channel ·1·.
V.PLC.DM00C2 Channel ·2·.
V.PLC.DM00C3 Channel ·3·.
V.PLC.DM00C4 Channel ·4·.
V.PLC.DM03 Spindle ·1·.
V.PLC.DM03SP1 Spindle ·1·.
V.PLC.DM03SP2 Spindle ·2·.
V.PLC.DM03SP3 Spindle ·3·.
V.PLC.DM03SP4 Spindle ·4·.
V.PLC.BLKSEARCH Channel ·1·.
V.PLC.BLKSEARCHC1 Channel ·1·.
V.PLC.BLKSEARCHC2 Channel ·2·.
V.PLC.BLKSEARCHC3 Channel ·3·.
V.PLC.BLKSEARCHC4 Channel ·4·.