Fagor CNC 8060 - Page 696

·696·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC consulting logic signals; general.
(V.)PLC.MSTROBE
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates this mark to indicate to the PLC that it must execute the M functions
indicated in MFUN1 through MFUN7.
(V.)PLC.HSTROBE
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates this mark to indicate to the PLC that it must execute the H functions
indicated in HFUN1 through HFUN7.
(V.)PLC.SFUN1
(V.)PLC.SFUN2
(V.)PLC.SFUN3
(V.)PLC.SFUN4
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel indicates in these registers the speed programmed in each spindle.
(V.)PLC.SSTROBE
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates this mark to indicate to the PLC that a new spindle speed has been
selected in registers SFUN1 through SFUN4.
(V.)PLC.DM00
(V.)PLC.DM01
(V.)PLC.DM02
(V.)PLC.DM06
(V.)PLC.DM08
V.PLC.MSTROBE Channel ·1·.
V.PLC.MSTROBEC1 Channel ·1·.
V.PLC.MSTROBEC2 Channel ·2·.
V.PLC.MSTROBEC3 Channel ·3·.
V.PLC.MSTROBEC4 Channel ·4·.
V.PLC.HSTROBE Channel ·1·.
V.PLC.HSTROBEC1 Channel ·1·.
V.PLC.HSTROBEC2 Channel ·2·.
V.PLC.HSTROBEC3 Channel ·3·.
V.PLC.HSTROBEC4 Channel ·4·.
V.PLC.SFUN1 Spindle ·1·.
V.PLC.SFUN2 Spindle ·2·.
V.PLC.SFUN3 Spindle ·3·.
V.PLC.SFUN4 Spindle ·4·.
V.PLC.SSTROBE Channel ·1·.
V.PLC.SSTROBE1 Channel ·1·.
V.PLC.SSTROBE2 Channel ·2·.
V.PLC.SSTROBE3 Channel ·3·.
V.PLC.SSTROBE4 Channel ·4·.