Fagor CNC 8060 - Page 715

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·715·
PLC modifiable logic signals; general.
(V.)PLC.CYSTART
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the execution of the part-program begins.
(V.)PLC.SBLOCK
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the channel activates the single-block mode.
(V.)PLC.MANRAPID
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the CNC selects the rapid traverse for jog movements.
(V.)PLC.OVRCAN
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the channel applies 100% of the feedrate in all work mode.
(V.)PLC.LATCHM
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
With this mark, it is possible to select how the JOG keys will work in JOG mode.
If this mark is off, the axes will move while the corresponding JOG key kept pressed. If this
mark is on, the axes will move from the instant the JOG key is pressed until the software limits
V.PLC.CYSTART Channel ·1·.
V.PLC.CYSTARTC1 Channel ·1·.
V.PLC.CYSTARTC2 Channel ·2·.
V.PLC.CYSTARTC3 Channel ·3·.
V.PLC.CYSTARTC4 Channel ·4·.
V.PLC.SBLOCK Channel ·1·.
V.PLC.SBLOCKC1 Channel ·1·.
V.PLC.SBLOCKC2 Channel ·2·.
V.PLC.SBLOCKC3 Channel ·3·.
V.PLC.SBLOCKC4 Channel ·4·.
V.PLC.MANRAPID Channel ·1·.
V.PLC.MANRAPIDC1 Channel ·1·.
V.PLC.MANRAPIDC2 Channel ·2·.
V.PLC.MANRAPIDC3 Channel ·3·.
V.PLC.MANRAPIDC4 Channel ·4·.
V.PLC.OVRCAN Channel ·1·.
V.PLC.OVRCANC1 Channel ·1·.
V.PLC.OVRCANC2 Channel ·2·.
V.PLC.OVRCANC3 Channel ·3·.
V.PLC.OVRCANC4 Channel ·4·.