Fagor CNC 8060 - Page 716

·716·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC modifiable logic signals; general.
are reached or the [STOP] key is pressed or another JOG key is pressed (in this case the
new axis will start moving).
(V.)PLC.RESETIN
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the channel assumes the initial conditions.
(V.)PLC.AUXEND
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC uses this mark when executing functions S and M with synchronization.
(V.)PLC.BLKSKIP1
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the channel considers the block-skip condition.
(V.)PLC.M01STOP
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the channel considers the block-skips.
V.PLC.LATCHM
V.PLC.RESETIN Channel ·1·.
V.PLC.RESETINC1 Channel ·1·.
V.PLC.RESETINC2 Channel ·2·.
V.PLC.RESETINC3 Channel ·3·.
V.PLC.RESETINC4 Channel ·4·.
V.PLC.AUXEND Channel ·1·.
V.PLC.AUXENDC1 Channel ·1·.
V.PLC.AUXENDC2 Channel ·2·.
V.PLC.AUXENDC3 Channel ·3·.
V.PLC.AUXENDC4 Channel ·4·.
V.PLC.BLKSKIP1 Channel ·1·.
V.PLC.BLKSKIP1C1 Channel ·1·.
V.PLC.BLKSKIP1C2 Channel ·2·.
V.PLC.BLKSKIP1C3 Channel ·3·.
V.PLC.BLKSKIP1C4 Channel ·4·.
V.PLC.M01STOP Channel ·1·.
V.PLC.M01STOPC1 Channel ·1·.
V.PLC.M01STOPC2 Channel ·2·.
V.PLC.M01STOPC3 Channel ·3·.
V.PLC.M01STOPC4 Channel ·4·.