Fagor CNC 8060 - Page 721

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·721·
PLC modifiable logic signals; general.
(V.)PLC.SLIMITAC
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC activates this mark, the CNC activates the speed safety limits (parameter SLIMIT)
on all the spindles of the system.
(V.)PLC.INT1
··
(V.)PLC.INT4
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC activates one of these marks, the channel executes the corresponding interruption
subroutine.
V.PLC.SLIMITAC
V.PLC.INT1 Channel ·1·.
V.PLC.INT1C1 Channel ·1·.
V.PLC.INT1C2 Channel ·2·.
V.PLC.INT1C3 Channel ·3·.
V.PLC.INT1C4 Channel ·4·.