·74·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
General machine parameters.
PLC TYPE.
PLCTYPE
PLC type.
Possible values: IEC / IEC+Fagor / Fagor.
Default value: IEC.
Associated variable: (V.)MPG.PLCTYPE
This parameter selects the type of PLC to be used; the Fagor one, the standard IEC-61131
or both. The following table shows who is affected by the startup (RUN) and stop (STOP)
of the PLC depending on this parameter as well as the status of the mark PLCREADY.
RENAME THE AXES AND THE SPINDLES.
RENAMECANCEL
Cancel the name change for the axes and the spindles.
Possible values: Yes / No.
Default value: Yes.
Associated variable: (V.)MPG.RENAMECANCEL
The #RENAME instruction may be used to rename the axes and spindles via part-program
or MDI/MDA mode. This parameter indicates whether the CNC keeps or cancel the names
of the axes and spindles (#RENAME) after executing M02 or M30, after a reset or at the
beginning of a new part-program in the same channel.
After turning the CNC off and on, the axes and spindles always keep their new name, except
after a checksum error or after validating the machine parameters that involve restoring the
original configuration of channels, axes or spindles. In either case, the axes and the spindles
will recover their original names.
ZERO OFFSETS.
FINORG
Fine definition of zero offsets.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)MPG.FINEORG
This parameter enables the possibility to set each zero offset in the zero offset table with a
coarse (or absolute) value and a fine (incremental) one. When executing function G159, the
CNC assumes as new zero offset the sum of both parts.
REMOTE MODULE RCS-S (SERCOS COUNTER).
NSERCOUNT
Number of Sercos counter nodes in the bus.
Possible values: From 0 to 8.
Default value: 0.
Number of RCS-S modules in the bus.
PLCTYPE RUN STOP PLCREADY
IEC Fagor IEC Fagor IEC Fagor
IEC Yes No Yes No ON - - -
IEC+Fagor Yes Yes Yes Yes ON ON
Fagor No Yes No Yes OFF ON
To Next Page
Loading...
