Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·75·
General machine parameters.
SERCOUNTID n
Table of thumbwheel identifiers associated to the Sercos
counters.
Possible values: From 1 to 15.
These parameters may be used to assign a logic number to the RCS-S modules of the bus
based on their physical address, set by its rotary switch (node number). Define in each
parameter the address (node number) of the RCS-S module.
Although the Sercos ring may have up to 32 nodes, the RCS-S modules always occupy
positions from 1 to 15.
ACCESS TO THE PARAMETER TABLE OF THE CHANNEL.
CHANNEL n
Parameter table of channel.
This parameter shows the machine parameter table of the channel.
To Next Page
Loading...
