·800·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to spindle speed.
SPINDLE SPEED IN G96 (CSS).
(V.)[ch].A.CSS.sn
(V.)[ch].SP.CSS.sn
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Active spindle speed in G96.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
Remarks.
The speed may be set by program or by PLC; the one set by PLC has the highest priority.
(V.)[ch].PLC.CSS.sn
Variable that can be read and written from the PLC and read from the program and from the interface.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Speed active by PLC for G96.
The speed programmed by PLC prevails over the one programmed by program or MDI. To
cancel the speed by PLC, set the variable to ·0·; the CNC applies the speed active by
program.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
V.A.CSS.S Spindle S.
V.SP.CSS.S Spindle S.
V.SP.CSS Master spindle.
V.A.CSS.5 Spindle with logic number ·5·.
V.SP.CSS.2 Spindle with index ·2· in the system.
V.[2].SP.CSS.1 Spindle with index ·1· in the channel ·2·.
Speed set. V.PLC.CSS.sn V.A.PRGCSS.sn V. A. CS S .s n
By program; S150.
By PLC; none.
0 150 150
By program; S150.
By PLC; S250.
250 150 250
By program; S150.
By PLC; S100.
100 150 100
By program; S150.
By PLC; none.
By MDI; S300.
0 300 300
By program; S150.
By PLC; S250.
By MDI; S200.
250 200 250
By program; S150.
By PLC; S100.
By MDI; S200.
100 200 100
V.PLC.CSS.S2 Spindle S2.
V.PLC.CSS.5 Spindle with logic number ·5·.
V.[2].PLC.CSS.1 Spindle with index ·1· in the channel ·2·.
To Next Page
Loading...
