Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·825·
Variables associated with any tool.
Values of the variable.
This variable returns one of the following values.
(V.)TM.TURNCONFIGT[tl][ofd]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
[odf] offset of the [tl] tool. Axis orientation.
Only for turning tools. The orientation of the axes is determined by the type of lathe (horizontal
or vertical), the position of the turret and the spindle position (on the right or on the left).
Syntax.
·tl· Tool number.
[odf] Tool offset; if missing, the active tool offset.
Value. Meaning. Value. Meaning.
0 Without type. 8 Surface milling endmill.
1 Flat endmill. 9 Reamer.
2 Ball endmill. 10 Boring tool.
3 Toric endmill. 11 Diamond shaped cutter for turning.
4 Tap. 12 Square cutter for turning, grooving or
cut-off.
5 Thread cutter. 13 Round cutter for turning.
6 Disk endmill. 14 Measuring probe (milling machine).
7 Drill bit. 15 Measuring probe (lathe).
V.TM.TURNCONFIGT[23] Tool ·23·. Active tool offset.
V.TM.TURNCONFIGT[23][3] Tool ·23·. Tool offset ·3·.
To Next Page
Loading...
