·834·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables associated with the tool being prepared.
TOOL GEOMETRY.
(V.)[ch].G.DSUBTYPE
Variable that can be read from the program.
The variable returns the value of block preparation.
Tool being prepared. Code of the tool offset subtype.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
V.[2].G.DSUBTYPE Channel ·2·.
Value. Meaning. Value. Meaning.
0 Without type. 8 Surface milling endmill.
1 Flat endmill. 9 Reamer.
2 Ball endmill. 10 Boring tool.
3 Toric endmill. 11 Diamond shaped cutter for turning.
4 Tap. 12 Square cutter for turning, grooving or
cut-off.
5 Thread cutter. 13 Round cutter for turning.
6 Disk endmill. 14 Measuring probe (milling machine).
7 Drill bit. 15 Measuring probe (lathe).
To Next Page
Loading...
