Fagor CNC 8060 - Page 835

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·835·
Variables associated with the tool being prepared.
(V.)[ch].G.LOCODE
Variable that can be read from the program.
The variable returns the value of block preparation.
[odf] offset of the tool being prepared. Location code (shape) or tool calibration point.
Only for turning tools. The location code indicates which is the calibrated tool tip and,
therefore, the point controlled by the CNC to apply radius compensation. The location code
depends on the orientation of the machine axes.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].G.TOR
Variable that can be read and written from the program.
The variable returns the value of block preparation.
Tool being prepared. Radius.
This variable is not valid for turning tools.
Syntax.
·ch· Channel number.
V.[2].G.LOCODE Channel ·2·.
Value.
0
1
2
3
4
5
6
7
8
9
V.[2].G.TOR Channel ·2·.