Fagor CNC 8060 - Page 837

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·837·
Variables associated with the tool being prepared.
(V.)[ch].G.TOWTIPR
Variable that can be read and written from the program.
The variable returns the value of block preparation.
Tool being prepared. Tool tip radius wear.
Syntax.
·ch· Channel number.
(V.)[ch].G.TOCUTL
Variable that can be read and written from the program.
The variable returns the value of block preparation.
Tool being prepared. Cutting length.
Syntax.
·ch· Channel number.
(V.)[ch].G.NOSEA
Variable that can be read and written from the program.
The variable returns the value of block preparation.
Tool being prepared. Cutter angle.
Syntax.
·ch· Channel number.
(V.)[ch].G.NOSEW
Variable that can be read and written from the program.
The variable returns the value of block preparation.
Tool being prepared. Cutter width.
Syntax.
·ch· Channel number.
(V.)[ch].G.CUTA
Variable that can be read and written from the program.
The variable returns the value of block preparation.
Tool being prepared. Cutting angle of the cutter.
Syntax.
·ch· Channel number.
(V.)[ch].A.TOFL.xn
Variable that can be read and written from the program.
Variable valid for rotary and linear axes.
The variable returns the value of block preparation.
Tool being prepared. Tool length offset on the xn axis.
On turning tools, it is used to define the tool length in each axis. On milling tools, it is used
to define the tool position when using a tool holder or an intermediate tooling.
V.[2].G.TOWTIPR Channel ·2·.
V.[2].G.TOCUTL Channel ·2·.
V.[2].G.NOSEA Channel ·2·.
V.[2].G.NOSEW Channel ·2·.
V.[2].G.CUTA Channel ·2·.