Fagor CNC 8060 - Page 85

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·85·
General machine parameters. Execution channels.
CSCANCEL
Cancel the inclined plane on start-up.
Possible values: Yes / No.
Default value: Yes.
Associated variable: (V.)[ch].MPG.CSCANCEL
This parameter indicates whether on start-up the CNC cancels the inclined plane
(#CS/#ACS) that was active when the CNC was turned off.
LINKCANCEL
Cancel axis coupling by default.
Possible values: Yes / No.
Default value: Yes.
Associated variable: (V.)[ch].MPG.LINKCANCEL
This parameter indicates whether the active axis couplings (#LINK) are canceled or not at
the end of the part-program, after an emergency or after a reset.
MIRRORCANCEL
Cancel mirror image (G11/G12/G13/G14) after M30 and reset.
Possible values: Yes / No.
Default value: Yes.
Associated variable: (V.)[ch].MPG.MIRRORCANCEL
This parameter indicates whether mirror image is cancelled or not at the end of the part
program or after a reset.
SLOPETYPE
Default acceleration type.
Possible values: Linear / Trapezoidal / Square sine (bell shaped).
Default value: Square sine (bell shaped).
Associated variable: (V.)[ch].MPG.SLOPETYPE
This parameter indicates the type of acceleration applied by default in automatic movements.
There are three types of acceleration, namely: linear, trapezoidal and square sine (bell
shaped). It is recommended to use square-sine type acceleration. When working in manual
(JOG) mode, the CNC always applies linear acceleration.
The dynamics of trapezoidal and square sine (bell shaped) accelerations are similar.
Trapezoidal acceleration may be used to program ramps in order to smooth out the acc/dec
changes. The square sine acceleration is an improvement to the trapezoidal acceleration;
it smoothes out the jerk so the movements are softer and the axis mechanics suffers less.
Depending on the type of acceleration selected, the machine parameters will show the ones
needed to configure the acceleration. To select a different acceleration via part-program, for
the automatic mode, use the instruction #SLOPE.
Description of the types of acceleration.
Square-sine acceleration provides the system's best response. The movements are
smoother and the axis mechanics does not suffer as much. Linear acceleration provides the
poorest response.
Linear
Trapezoidal
Square Sine
(Bell Shaped)
a
a
a
t
t
t