Fagor CNC 8060 - Page 856

·856·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the programmed functions.
Remarks.
This variable returns the result in the least significant bits, one per axis (1= active and 0=not
active). The least significant bit is for the first axis, the next one for the second axis and so on.
(V.)[ch].G.MIRROR1
(V.)[ch].G.MIRROR2
(V.)[ch].G.MIRROR3
Variable that can be read from the program.
The variable returns the value of block preparation.
Mirror image active on the first axes of the channel.
Syntax.
·ch· Channel number.
GEOMETRIC ASSISTANCE. SCALING FACTOR.
(V.)[ch].G.SCALE
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
It indicates the active general scaling factor.
Syntax.
·ch· Channel number.
GEOMETRIC ASSISTANCE. COORDINATE SYSTEM
ROTATION.
(V.)[ch].G.ROTPF
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Position of the rotation center referred to part zero (abscissa).
Syntax.
·ch· Channel number.
(V.)[ch].G.ROTPS
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Position of the rotation center referred to part zero (ordinate).
Syntax.
·ch· Channel number.
V.[2].G.MIRROR1 Channel ·2·. First axis of the channel.
V.[2].G.MIRROR2 Channel ·2·. Second axis of the channel.
V.[2].G.MIRROR3 Channel ·2·. Third axis of the channel.
V.[2].G.SCALE Channel ·2·.
V.[2].G.ROTPF Channel ·2·.
V.[2].G.ROTPS Channel ·2·.